| Ground | LNS_GND | Lancaster Ground | 121.800 | HN |
| Tower | LNS_TWR | Lancaster Tower | 120.900 | HM |
| ATIS | KLNS_ATIS | 125.670 |
New York ARTCC
Standard Operating Procedure — LNS
Rev. 2 — Revised: 2025-03-01
Area at a glance
| ICAO Code | Airport Name | Airspace |
|---|---|---|
| KLNS | Lancaster Airport | D |
- Purpose
- This document prescribes the procedures to be utilized for providing air traffic control services at Lancaster Air Traffic Control Tower (ATCT). The procedures described herein are supplemental to the New York ARTCC Standard Operating Procedures and FAA Order JO 7110.65.
- Distribution
- This order is distributed to all New York ARTCC personnel.
- Procedural Deviations
- Exceptional or unusual requirements may dictate procedural deviations or supplementary procedures to this order. A situation may arise that is not adequately covered herein; in such an event use good judgment to adequately resolve the problem.
Operational Positions
| Sector | Callsign | Frequency | Identifier | Combined Sector |
|---|---|---|---|---|
| Harrisburg (HAR) | MDT_SW_APP | 124.100 | HK | Primary TRACON |
| Lancaster (LRP) | MDT_SE_APP | 126.450 | HS | |
| Ravine (RAV) | MDT_N_APP | 118.250 | HG | |
| Reading | RDG_APP | 125.150 | RX | Covered by MDT TRACON 0000-0600 local time |
Notes:
- When RDG_APP is not staffed, MDT TRACON may provide top-down services at RDG regardless of local time.
- When splitting MDT TRACON, split into HAR & LRP sectors first.
ATCT
Clearance Delivery
| Exit Gate | Exit | Scratchpad |
|---|---|---|
| North (N) | GAAPP | GAA |
| SEG | SEG | |
| Northeast (NE) | ETX | ETX |
| LVZ | LVZ | |
| FJC | FJC | |
| East (E) | LRP | LRP |
| PTW | PTW | |
| ARD | ARD | |
| Southeast (SE) | DQO | DQO |
| Southwest (SW) | HAR | HAR |
| BRNAN | BRN | |
| JST | JST | |
| VINSE | VIN | |
| THS | THS | |
| SCAPE | SCA | |
| GRAMO | GRA | |
| MRB | MRB | |
| EMI | EMI | |
| Northwest (NW) | MCMAN | MCM |
| PSB | PSB |
Notes
- While strict exit direction points are not required at LNS, the guide above may come in handy for directing pilots to proper exits for departing the area.
- KIACK is only a valid exit of preceded by GAAPP. The route must therefore read GAAPP KIACK...
- MCMAN is used for aircraft routed via V33/J64/Q62.
- Traffic filed via EMI to join J48 should be re-routed via GRAMO VINNY EMI.
| Position | Frequency | Code |
|---|---|---|
| MDT_SE_APP | 126.45 | HS |
| MDT_E_APP | 126.450 | HS |
| MDT_APP | 124.100 | HK |
| NY_CTR | 125.325 | N56 |
The table above lists the common frequencies used as departure frequency by LNS Clearance Delivery. The first available controller in this list should be handling departures.
Note that this table only serves as a guide. The actual departure frequency has to be determined based on coordination with the other online controllers.
If there is no other controller online that would accept departures from LNS, use LNS CTAF (120.900).Routing to certain airports in ZNY, ZDC and ZBW ARTCCs is pre-coordinated through letters of agreement (LOA). These routes have been added to the Preferred Route Database (PRD). Therefore, PRD must be referenced for all departures.
Notes
- The initial altitude for IFR departures of all types is 3,000’ whereas higher may be expected in 10 minutes after departure.
- There is no published departure procedure out of Lancaster. All aircraft must be cleared to their destination via radar vectors to an LNS exit.
- Traffic filed via EMI to join J48 should be re-routed via GRAMO VINNY EMI.
Muir is a Class D airport. All VFR traffic must maintain two-way radio communication. See the VFR Operations document for detailed explanation of applicable VFR procedures.